Ezra C
- Total activity 121
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 2
- Subscriptions 55
Comments
Recent activity by Ezra C-
Hi David You can measure all three phases with 3 Pokit Pros similar to below the easiest way to make this measurement is to configure the three Pokit Pros in a star configuration with the three bl...
-
Thanks for this BJerew. We'll add this to our to-do bucket!
-
Hello Lucadio Gutierrez, In the multimeter and logger modes we currently only support 40-120hz but the DSO modes can measure up to ~100kHz accurately (with probe compensation) so you could use that.
-
Hey Rob, The Pokit Pro should handle it as the 10A rating on the fuse is for a constant current. The fuse should be ok for a 1 second inrush of 20A, The characteristic curve shows it should survive...
-
Official comment Hello Valued Pokiteers!We have some exciting news to share with you! After carefully listening to your feedback, we’ve made a significant change to the Range Tester App Module. **NO SUBSCRIPTION, O...
-
Hello X, You will not need to be always connected to the internet to use the upcoming range tester module. You may read about it on this FAQ article:Do I need to be connected to the internet in ord...
-
Hello BJerew! On the upcoming iOS app update, you will be able to pinch and pan around waveforms and logger files in your history view (you may need to make a new measurement), similar to how you c...
-
Hi Bill Jamieson, The Range Tester for iPhone will be released worldwide very soon. Most likely within 2-4 weeks. The prices are still to be released.
-
Hello Nick van Laarhoven, Can you try rebooting your Pokit Pro and testing again? To reboot, you will need to press and hold down its button for 15 seconds. You should see the light flash or a mome...
-
Hi Stolarski Ronen, It depends, I assume you are using a Pokit Pro? If you expect the load to be small (<50mA) you can use the middle switch position (low current), otherwise use the rear switch po...