Shane Christopherson
- Total activity 66
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 7
- Subscriptions 25
Comments
Recent activity by Shane Christopherson-
Should be able to just watch the battery voltage with the oscilloscope in continuous mode and adjust the time base to see irregularities. Just like watching the ripple on a bench power supply. Ris...
-
I got my new case, it is slightly longer than the one pictured above. I've featured it on a YouTube video, here is the link as well as a photo of the Pokit Pro in the new case. https://youtu.be/aY...
-
Same issue here but I just picked up a slightly bigger smart phone case to hold all the stuff, picture below. I'm afraid the cases would get separated if I was carrying around two of them. This c...
-
FYI, I also tried the datalogging mode for this same test and 500 ms is not sufficient to capture enough data points. Here is a screen shot of the same test in datalogging mode. Only captures a co...
-
Just tried using the datalogging mode and as expected 500 ms is not fast enough for this. Same car that we know goes down to 9-10 volts during crank the datalogging only captured down to 11.35 VDC...
-
Great, thanks for the update.
-
500ms is the fastest interval for data point collection in the current software. It will run for much longer than 30 minutes, that's not a problem. I was able to data log the temperature in my ga...
-
This is an old thread but I figured I'd share my experience after receiving my Pokit Pro. It will indeed measure mains voltage directly with no special probe. I measured mains voltage with the mu...
-
I see a calibration button on the temperature mode on the Pokit Pro but didn't notice it anywhere else yet. Where would be find instructions on how to calibrate the various modes?
-
Anyone determined yet if the magnet interferes with any of the Pokits measurements? Run some bench tests with and without the magnet on the same signal or voltage supply? I received my Pokit Pro ...