Pokit Pro no measurements after upgrading to Firmware V2.0.0
Issue: No measurement after upgrading firmware to V2.0.0
Modes checked: VDC, VAC, R, Continuity, Capacitance checked (other modes unchecked)
Device info: PokitPro HW: V1.0, FW to V2.0.0, App V2.01, Serial # 3364
The device was fully charged and paired with an Oppo / Android phone running the Pokit App.
Connection status: Ok
Fuses checked: 500mA and 10A fuses are both ok.
Upon pressing the "Locate" button in the app, the following error message appears:
“GATT exception from MAC='5C:02:72:09:A8:F9', status 128 (GATT_NO_RESOURCES), type BleGattOperation{description='CHARACTERISTIC_WRITE'}. (Look up status 0x80…”
The Fix:
Delete the Pokit Pro Bluetooth record from the phone settings.
Unpair the Pokit Pro from the app and pair it again.
Problem resolved.
I'm posting this in case other people have the same problem.
-
Hi David,
Thanks for sharing it with us. This is definitely gonna be helpful for other people who might encounter the same.
0 -
After firmware 2.0.2 my poket doesn't measure anything, not even continuity.
FW: 2.0.2
HW: v1.0
Connection / pairing works fine, tested on iPhone 15 pro and iPad m4 Pro. I can toggle the torch, but don't get any values nor beep with continuity (within the app nor pokit pro device)
The fuses are ok. I never measured anything more then 24v.0 -
Hello Nick van Laarhoven,
Can you try rebooting your Pokit Pro and testing again?
To reboot, you will need to press and hold down its button for 15 seconds. You should see the light flash or a moment and hear a beep indicating it rebooted.
Once done, check if it's measuring again.
If the issue persists, you may submit a ticket request to our help desk via this link: https://help.pokitmeter.com/hc/en-us/requests/new
0
Please sign in to leave a comment.
Comments
3 comments